Universal Joints/Vibration Resistors
Universal Joints/Vibration Resistors
VIBRATION RESISTORS DOUBLE NEEDLE BEARING UNIVERSAL JOINTS
STEERING UNIVERSAL JOINTS
Double D Sizes and Borgeson Equivalent
Nominal Approximate Approximate Size Borgeson Size Diameter (A) Across Flats (B) Designation 17 mm Double D .670 .570 6DD 3/4" Double .750 .550 7DD 1" Double D .993 .790 1DD
PRICE GUIDE
NEEDLE BEARING UNIVERSAL JOINTS - Steel or Stainless Steel
Available Combinations Steel Single Steel Double Smooth Bore both ends $59.95 $119.95 Smooth Bore and Spline or Double D $64.50 $124.95 Spline and/or Double each end $68.00 $129.95
SPLINED SHAFTING - Steele and Stainless Steel
Steel - Splined both ends Stainless - Splined both ends 4" to 16" long $29.95 Less than 16" $53.95 18" to 36" long $31.95 16" plus to 36" $57.95 5", 16" or 36" splined one end only $19.00 Splined one end only $33.95 2" splined full length $19.95 Add $15.00 for polishing
Double D Entire Length (Steel Only) Rod End Bearings 18" Long $19.95 For 3/4" Shafting $31.9536" Long $21.95 Stainless Steel $105.95
VIBRATION REDUCER $93.95 Female Coupler both ends Female Coupler and Splined Male Shaft Male Shaft both ends S736 x C526 S736 x CTDD C736 x C636 C7DD x C526
C736 x C730 C7DD x C636
C736 x C736 C7DD x C730
S736 x C526 S736 x 0526 S736 x C636 S736 x C7DD
S736 x C730
S736 x S736
VIBRATION REDUCER Combined with U-JOINT Female Coupler and any yoke $146.95
COUPLERS AND ADAPTERS Couplers Adapters All sizes EXCEPT 148, and 1DD $16.95 A-10R $6.45 C736X2 splined through $19.95 A-12R $6.45 C148 or C1DD $23.95
REQUIRED INFORMATION
BOX or RACK: Manual_____ Power_____ Year____ Model____ Diameter____ # teeth in full circle______
COLUMN: Diameter of column shaft________ Splined_______ "Double D"________ Plain________
If above information is unknown see below
TO DETERMINE SPLINE NOT ON THE APPLICATION CHART
(1) Measure the outer diameter of the column, box or pinion shaft over the splines.
(2) Determine the number of splines in a full circle. If there is a flat spot or teeth missing, count the number of splines half way around an area where there are continuous splines and double the number. Compare this to the chart. If unsure of spline or it is difficult to count and measure, a hardened clay mold may be made and sent to us.
(3) If the shaft is a "Double D" measure across the widest point.
All Prices subject to change without notice. |
Last Updated:
|
||
Copyright © 2000-2003 - Zig's Street Rod Center Inc. |