1. | Preparing the frame: |
|
Remove the original engine and transmission. |
|
Clean the frame of any dirt and rust, especially around the area where the motor mounts need to be welded (see illustration). |
2. | Installing Motor Mounts |
|
Mock up the new engine and transmission into the fame. |
|
Check for clearance and interference (fan to radiator, firewall, exhaust to steering). |
|
Locate the motor mount location in frame, a reference dimension is given in the illustration, and mark the frame where the motor mounts are positioned. |
|
The motor mounts are marked left and right. If there is a doubt, the tubes for the 7/1 6 x 4" bolts should be lower in the rear than on the front. |
|
Remove engine and transmission. |
|
Position motor mounts where the frame is marked and tack weld in place. |
|
Double check measurement for location and squareness. |
|
Final weld mounts. |
|
Paint over welded and bare metal area. |
|
Install engine and transmission. |
All Prices subject to change without notice. |
Last Updated:
|
||
Copyright © 2000-2003 - Zig's Street Rod Center Inc. |